航天推进技术研究院主办
[1]刘成胜,王晓锋,赵艳丽,等.试验系统夹气对离心泵性能测量的影响分析[J].火箭推进,2018,44(06):75-80.
LIU Chengsheng,WANG Xiaofeng,ZHAO Yanli,et al.Analysis on influence of gas entrapment of test system on centrifugal pump performance measuring[J].Journal of Rocket Propulsion,2018,44(06):75-80.
点击复制
LIU Chengsheng,WANG Xiaofeng,ZHAO Yanli,et al.Analysis on influence of gas entrapment of test system on centrifugal pump performance measuring[J].Journal of Rocket Propulsion,2018,44(06):75-80.
试验系统夹气对离心泵性能测量的影响分析
《火箭推进》[ISSN:1672-9374/CN:CN 61-1436/V]
卷:
44
期数:
2018年06期
页码:
75-80
栏目:
测控与试验
出版日期:
2018-12-31
- Title:
- Analysis on influence of gas entrapment of test system on centrifugal pump performance measuring
- 文章编号:
- 1672-9374(2018)06-0075-06
- Keywords:
- test system; gas entrapment; performance measurement; delivery head
- 分类号:
- V431-34
- 文献标志码:
- A
- 摘要:
- 针对试验系统夹气所产生的破坏,需要研究试验系统夹气对离心泵性能测量的影响,分别从扬程、效率、功率及汽蚀余量公式对离心泵性能的影响因素进行研究,根据理论公式和试验系统夹气带来的密度、流量等变化分析了夹气对离心泵测量性能的影响。在试验系统夹气情况下对流量计位于泵和调节阀之间与泵出口调节阀之后的影响进行了分析。试验结果表明,试验系统夹气会造成测量的离心泵扬程(用压力表示的扬程)和效率提高、功率降低、汽蚀余量增大; 流量计位于离心泵和调节阀之间,试验系统夹气时,测量的扬程(用压力表示的扬程)、效率和功率都接近未夹气时的结果; 流量计位于调节阀之后,试验系统夹气时测量的离心泵扬程(用压力表示的扬程)和效率都高于未夹气时的结果,功率降低。由于流量计位置对测量的影响,在设计试验系统时尽可能把流量计设置在离心泵与调节阀之间。
- Abstract:
- Since there is a damage caused by gas entrapment of test system, it is necessary to study the influence of gas entrapment of the test system on the centrifugal pump performance measurement.The influence factors of the theoretical formula of delivery head, efficiency, power and NPSH on the performance of centrifugal pump were analyzed in this paper.According to the theoretical formula and density and flow rate changes caused by gas entrapment of the test system, the influences of gas entrapment on the measurement of centrifugal pump performance were analyzed.In the case of gas entrapment of the test system, the measured different results were analyzed when the flow meter is located between the pump and regulating valve or after regulating valve at pump outlet.The results show that the gas entrapment of the test system may result in increase of delivery head, efficiency and NPSH, but decrease of centrifugal pump power.The results measured while executing gas entrapment are close to the results before executing gas entrapment when flow meter is located between the centrifugal pump and the regulating valve.When flow meter is located after the regulating valve, the results measured of delivery head, efficiency are higher than those before executing gas entrapment.Because of the influence of the flow meter position on measuring result, flow meter should be located between centrifugal pump and regulating valve so far as possible in design of the test system.
参考文献/References:
[1] GB/T 3216-2016《回转动力泵水力性能验收试验1级、2级和3级》[S].
[2] GB/T 18149-2000《离心泵、混流泵和轴流泵水力性能试验规范精密级》[S].
[3] 关醒凡.泵的理论与设计[M].北京:机械工业出版社,1987.
[4] 宋立,赵静,许德忠,等.AP 1000(第三代核电)正常余热排出泵加气试验性能参数的理论分析[J].水泵技术,2014(3):10-12, 23.
[5] 关醒凡.现代泵技术手册[M].北京:宇航出版社,1998.
[6] ПЕТРОВ В И, ЧАБАЕВСКИЙ В Ф.Кавитация в высоко-оборотных лопастных насосах [M].[S.l.]: Машиностроение, 1982.
[7] 谢鹏,朱祖超.低比转速离心旋涡泵的气液混输汽蚀试验研究[J].水利学报,2009,12(40):1506-1511.
[8] 郑海梦.泵测试实用技术[M].北京:机械工业出版社,2006.
[9] 潘中永、袁寿其.泵空化基础[M].镇江:江苏大学出版社,2006.
[10] 钱红军,韦章兵.气体对离心泵性能影响的试验研究[J].流体机械,2003,31(7):1-4.
[11] 陈斌,胡家顺.离心泵的溶气试验研究[J].化学工程与装备,2014(7):29-31.
[12]黄智勇,胡钟兵,李惠敏.大功率、高转速、高扬程涡轮泵振动分析与减振研究[J].火箭推进,2005,31(6):1-6.
HUANG Z Y, HU Z B, LI H M.Analysis of vibration and vibration reduction for turbopumps with highpower, high-rotation speed and high-delivery-head[J].Journal of rocker propulsion,2005,31(6):1-6.
相似文献/References:
[1]赵耀中,郑 然,彭龙涛,等.运载火箭氧自生增压不锈钢管道的安全性研究[J].火箭推进,2015,41(06):105.
ZHAO Yaozhong,ZHENG Ran,PENG Longtao,et al.Study on reliability of stainless steel tube for
self-pressurization oxygen tank of launch vehicle[J].Journal of Rocket Propulsion,2015,41(06):105.
[2]王 珺,胡 鹏,颜 勇.液体火箭发动机泵的POGO气蚀动特性试验研究[J].火箭推进,2012,38(04):26.
WANG Jun,HU Peng,YAN Yong.Experimental investigation of POGO cavitation dynamic characteristic for liquid rocket engine pump[J].Journal of Rocket Propulsion,2012,38(06):26.
[3]朱 伟,王 昕.液体火箭发动机液流试验系统测量过程控制研究[J].火箭推进,2011,37(04):71.
ZHU Wei,WANG Xin.Measuring process control of liquid rocket engine liquid flow testing system[J].Journal of Rocket Propulsion,2011,37(06):71.
[4]朱伟.气动装夹在试验工装中的利用[J].火箭推进,2005,31(04):54.
Zhu Wei.Application of pneumatic equipment in test clamping apparatus[J].Journal of Rocket Propulsion,2005,31(06):54.
[5]侯健,贺宏,陈聪,等.发动机高模试验技术研究[J].火箭推进,2016,42(06):81.
HOU Jian,HE Hong,CHEN Cong,et al.Study on high altitude simulation test technology of engine[J].Journal of Rocket Propulsion,2016,42(06):81.
备注/Memo
收稿日期:2017-10-31; 修回日期:2018-05-22 基金项目: 国家重大基础研究项目(61321) 作者简介: 刘成胜(1978—),男,高级工程师,研究领域为液体试验
更新日期/Last Update:
2018-12-25