航天推进技术研究院主办
[1]史子鹏,杨永强,吕顺进,等.氦气驱动预压涡轮泵启动初期反流问题分析[J].火箭推进,2022,48(01):38-44.
SHI Zipeng,YANG Yongqiang,LYU Shunjin,et al.Analysis on backflow problem during initial start-up process of helium-driven pre-pressurized turbopump[J].Journal of Rocket Propulsion,2022,48(01):38-44.
点击复制
SHI Zipeng,YANG Yongqiang,LYU Shunjin,et al.Analysis on backflow problem during initial start-up process of helium-driven pre-pressurized turbopump[J].Journal of Rocket Propulsion,2022,48(01):38-44.
氦气驱动预压涡轮泵启动初期反流问题分析
《火箭推进》[ISSN:1672-9374/CN:CN 61-1436/V]
卷:
48
期数:
2022年01期
页码:
38-44
栏目:
研究与设计
出版日期:
2022-02-28
- Title:
- Analysis on backflow problem during initial start-up process of helium-driven pre-pressurized turbopump
- 文章编号:
- 1672-9374(2022)01-0038-07
- Keywords:
- pre-pressurized turbopump; drive; backflow; simulation
- 分类号:
- V434.2
- 文献标志码:
- A
- 摘要:
- 用于某液体火箭发动启动动系统的气驱预压涡轮泵在起动初期出现了气体反流,导致预压泵呈夹气状态,对发动启动动过程控制不利。根据驱动试验系统原理,在MWorks平台中对驱动过程进行了仿真。对预压泵采用了Suter全特性表达式,对涡轮管路及排放路分别建立了描述排空与两相流动过程的简化数学模型。结果表明,导致反流的原因为涡轮入口及出口管路存在液相积存条件下,氦气驱动排空过程中导致气液两相流动状态下压降升高,使氦气通过结构间隙大量进入泵端。可通过调整结构间隙、减小排放路流阻等措施来降低反流对启动过程的影响。
- Abstract:
- During the initial start-up process of the gas-driven pre-pressurized turbopump used in the start-up system of a liquid rocket engine,the gas backflow phenomenon occurred and it caused the pre-pressurized pump to be in the cavitation state,which was harmful to the control of engine start-up process. According to the principle of the driving test system,the driving process was simulated by the MWorks software. The Suter full-characteristic expression was adopted for the pre-pressurized pump. A simplified mathematical model was established to describe the emptying and two-phase flow processes for the turbine pipeline and the discharge pipeline. The results show that the backflow is caused by the liquid phase accumulation in the turbine pipeline,and the pressure drop of the two-phase flow is increased during the emptying process,so that a large amount of helium enters the pump end through the structural gap. The influence of backflow during the start-up process can be reduced by adjusting the structure gap or reducing the flow resistance of the discharge pipeline.
参考文献/References:
[1] 李元启,刘红军,徐浩海,等.液体火箭发动机动态特性仿真技术研究进展[J].火箭推进,2017,43(5):1-6.
LI Y Q,LIU H J,XU H H,et al. Research progress on numerical simulation technology of liquid rocket engine dynamic characteristics[J].Journal of Rocket Propulsion,2017,43(5):1-6.
[2] 尘军,王桁. 系统动态仿真技术在高压补燃氢氧发动机研制中的应用[J].导弹与航天运载技术,2002(5):29-35.
[3] 怀利,斯特里特. 瞬变流[M].清华大学流体传动与控制教研室,译.北京:水利电力出版社,1983.
[4] 别利亚耶夫,契万诺夫. 液体火箭发动机工作过程的数学模拟[M].牛晓丽,译. 西安:航天科技集团公司第六研究院第十一研究所,2015.
[5] 舍维科夫. 液体火箭发动机自动控制理论[M].张兴波,译. 西安:航天科技集团公司第六研究院第十一研究所,2002.
[6] 格列克曼. 液体火箭发动机自动调节[M].顾明初,译. 北京:宇航出版社,1995.
[7] 黄敏超,刘昆,邢宝玉. 液体火箭发动机动态性能分析[M].长沙:国防科技大学出版社,2015.
[8] KANMURI A,KANDA T,WAKAMATSU Y,et al. Transient analysis of LOX/LH2 rocket engine(LE-7)[C]//25th Joint Propulsion Conference. Reston,Virginia:AIAA,1989.
[9] SAHICK H D,KRULLE G. Numerical simulations of transition feed systems of cryogenic rocket engines[C]//31st AIAA Joint Propulsion Conference and Exhibit. Reston,Virginia:AIAA,1995.
[10] MATTEO F D,DE ROSA M,ONOFRI M. Start-up transient simulation of a liquid rocket engine[C]//47th AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit. Reston,Virginia:AIAA,2011.
[11] BELYAEV E N,CHVANOV V K,CHERVAKOV V V. The outflow of a two-phase gas-liquid mixture from the mixing head of a gas generator when starting a liquid-propellant rocket engine[J].High Temperature,2005,43(3):446-451.
[12] 王春民,张晓光,高玉闪,等.液氧煤油补燃发动机起动过程氧预压泵加速起旋方案研究[J].推进技术,2020,41(7):1441-1448.
[13] 杨永强,刘红军,徐浩海,等.补燃循环发动机强迫起动研究[J].火箭推进,2011,37(2):14-18.
YANG Y Q,LIU H J,XU H H,et,al. Research on forced start-up of staged combustion engine[J].Journal of Rocket Propulsion,2011,37(2):14-18.
[14] 李程,杨永强,徐浩海,等.500 t级液氧煤油补燃发动机起动过程仿真研究[J].火箭推进,2014,40(6):1-7.
LI C,YANG Y Q,XU H H,et al. Numerical simulation of start-up process for 500 t thrust LOX/kerosene staged combustion cycle rocket engine[J].Journal of Rocket Propulsion,2014,40(6):1-7.
[15] FRITZSON P. Modelica语言导论:技术物理系统建模与仿真[M].周凡利,译. 武汉:华中科技大学出版社,2020.
[16] 吴有亮. 基于Modelica的液体火箭发动机系统建模与仿真研究[D].北京:中国航天科技集团公司第一研究院,2018.
[17] 刘上,王艺杰,程晓辉,等.小推力泵压式发动机自身起动过程仿真分析[J].火箭推进,2016,42(4):7-13.
LIU S,WANG Y J,CHENG X H,et al. Simulation of self start-up process for low thrust pump-fed rocket engine[J].Journal of Rocket Propulsion,2016,42(4):7-13.
[18] 张萍. 预压涡轮泵水力性能试验系统[J].火箭推进,2003,29(6):23-25.
ZHANG P.Test system of hydraulic performance of a prepressurized turbopump[J].Journal of Rocket Propulsion,2003,29(6):23-25.
[19] BINDER M. A transient model of the RL10A-3-3A rocket engine[C]//31st Joint Propulsion Conference and Exhibit. Reston,Virginia:AIAA,1995.
[20] 尘军,王桁. 高压补燃氢氧发动机系统动态仿真[J].航天推进与动力,2008(2):15-21.
备注/Memo
收稿日期:2021-07-13; 修回日期:2021-08-29
基金项目:国家自然科学基金(51775412)
作者简介:史子鹏(1996—),男,硕士,研究领域为液体火箭发动机系统仿真。
更新日期/Last Update:
1900-01-01