航天推进技术研究院主办
[1]谢远,聂万胜,高玉超,等.流量脉动对针栓式喷嘴雾化特性影响的仿真分析[J].火箭推进,2023,49(01):54-64.
XIE Yuan,NIE Wansheng,GAO Yuchao,et al.Simulation analysis on the influence of flow pulsation on the atomization characteristics of a pintle injector[J].Journal of Rocket Propulsion,2023,49(01):54-64.
点击复制
XIE Yuan,NIE Wansheng,GAO Yuchao,et al.Simulation analysis on the influence of flow pulsation on the atomization characteristics of a pintle injector[J].Journal of Rocket Propulsion,2023,49(01):54-64.
流量脉动对针栓式喷嘴雾化特性影响的仿真分析
《火箭推进》[ISSN:1672-9374/CN:CN 61-1436/V]
卷:
49
期数:
2023年01期
页码:
54-64
栏目:
目次
出版日期:
2023-02-25
- Title:
- Simulation analysis on the influence of flow pulsation on the atomization characteristics of a pintle injector
- 文章编号:
- 1672-9374(2023)01-0054-11
- 分类号:
- V434
- 文献标志码:
- A
- 摘要:
- 针栓式喷嘴在变推力液体火箭中有重要应用。使用连续相到离散相方法和基于树形数据结构的自适应算法研究了气液针栓式喷嘴的雾化破碎过程,重点关注了液体流量脉动的影响。通过施加周期性变化的质量流量入口边界来模拟上游流量脉动下的雾化过程,对比了有无流量脉动条件下的雾化特性,研究了脉动频率对针栓式喷嘴雾化特性的影响。结果表明:当液体流量不变时,在气体的撞击作用下,液膜上剥落出较长的液丝,长液丝二次破碎为小液丝和大量液滴,破碎距离较长,液膜破碎过程比较有序 当流量脉动幅值为0.15,脉动频率的范围为500～3 000 Hz时,液膜破碎距离会缩短,液膜会形成明显的环状表面波,破碎后在环形液丝周围出现液滴聚集现象,雾化锥角受脉动频率影响较小 脉动频率会显著降低液滴的粒径,当频率较高(3 000 Hz)时,可能会产生数目较少的极大液滴粒径 液体流量脉动会使得液滴分布出现局部聚集现象,喷雾形态出现明显的“鼓包”结构。
- Abstract:
- Pintle injectors have important application in variable thrust liquid rockets.The continuous phase to discrete phase method and adaptive algorithm based on tree data structure were used to study the atomization and crushing process of a gas-liquid pintle injector, with emphasis on the effect of liquid flow pulsation.The atomization process under upstream flow pulsation was simulated by applying periodically varying mass flow inlet boundary, and the atomization characteristics with or without flow pulsation were compared.The influence of pulsation frequency on the atomization of the pintle injector was studied.The results show that when the liquid mass flow was constant, the long liquid filaments are separated from the liquid film under the impact of gas flow, and the long liquid filaments are broken into small liquid filaments and a large number of droplets.The broken distance is long, and the liquid film breaking process is orderly.When the flow pulsation amplitude was 0.15 and the pulsation frequency ranges from 500 Hz to 3 000 Hz, the crushing distance is shortened, the liquid film forms an obvious annular surface wave, and droplets gather around the annular liquid filament after crushing, and the atomization cone angle is less affected by the pulsation frequency.Pulsation frequencies significantly reduce droplet sizes, and at high frequencies(3 000 Hz), a small number of large droplet may be produced.The liquid flow fluctuation makes the droplet distribution appear local aggregation phenomenon, and the spray shape appears obvious “bulge” structure.
参考文献/References:
[1] 哈杰,里尔登.液体推进剂火箭发动机不稳定燃烧[M].朱宁昌,张宝炯,译.北京:国防工业出版社,1980.
[2] DRESSLER G.Summary of deep throttling rocket engines with emphasis on Apollo LMDE[C]//42nd AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit.Reston,Virginia:AIAA,2006.
[3] 石璞,朱国强,李进贤,等.液体火箭发动机针栓喷注器雾化燃烧技术研究进展[J].火箭推进,2020,46(4):1-13.
SHI P,ZHU G Q,LI J X,et al.Advances in atomized combustion technology research of pintle injector for liquid rocket engines[J].Journal of Rocket Propulsion,2020,46(4):1-13.
[4] CASIANO M J,HULKA J R,YANG V.Liquid-propellant rocket engine throttling:A comprehensive review[J].Journal of Propulsion and Power,2010,26(5):897-923.
[5] DRESSLER G,BAUER J.TRW pintle engine heritage and performance characteristics[C]//36th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit.Reston,Virginia:AIAA,2000.
[6] 王振国.液体火箭发动机燃烧过程建模与数值仿真[M].北京:国防工业出版社,2012.
[7] 王凯,雷凡培,杨岸龙,等.针栓式喷注单元膜束撞击雾化混合过程数值模拟[J].航空学报,2020,41(9):123802.
[8] 方昕昕,沈赤兵,成鹏,等.针栓式喷注器雾化特性试验[J].航空动力学报,2017,32(8):1853-1860.
[9] SAKAKI K,KAKUDO H,NAKAYA S,et al.Combustion characteristics of ethanol/liquid-oxygen rocket-engine combustor with planar pintle injector[J].Journal of Propulsion and Power,2016,33(2):514-521.
[10] NARDI R,PEREZ V,PIMENTA A.Experiments with pintle injector design and development[C]//51st AIAA/SAE/ASEE Joint Propulsion Conference.Reston,Virginia:AIAA,2015.
[11] SON M,YU K,KOO J,et al.Effects of momentum ratio and Weber number on spray half angles of liquid controlled pintle injector[J].Journal of Thermal Science,2015,24(1):37-43.
[12] SON M,YU K,RADHAKRISHNAN K,et al.Verification on spray simulation of a pintle injector for liquid rocket engine[J].Journal of Thermal Science,2016,25(1):90-96.
[13] YANG A L.Periodic atomization characteristics of simplex swirl injector induced by klystron effect[J].Chinese Journal of Aeronautics,2018,31(5):1066-1074.
[14] MILLER K,SISCO J,NUGENT N,et al.Combustion instability with a single-element swirl injector[J].Journal of Propulsion and Power,2007,23(5):1102-1112.
[15] POMEROY B,ANDERSON W.Transverse instability studies in a subscale chamber[J].Journal of Propulsion and Power,2016,32(4):939-947.
[16] AHN B,ISMAILOV M,HEISTER S D.Experimental study swirl injector dynamic response using a hydromechanical pulsator[J].Journal of Propulsion and Power,2012,28(3):585-595.
[17] CHAO C C,HEISTER S D.Contributions of atomization to F-1 engine combustion instabilities[J].Engineering Analysis with Boundary Elements,2004,28(9):1045-1053.
[18] ZHOU R,SHEN C B,JIN X.Numerical study on the morphology of a liquid-liquid pintle injector element primary breakup spray[J].Journal of Zhejiang University-SCIENCE A,2020,21(8):684-694.
[19] KIM D,OLIVIER D,MARCUS H,et al.The primary breakup of a round liquid jet by a coaxial flow of gas[EB/OL].https://www.researchgate.net/publication/251839 860_Toward_two-phase_simulation_of_the_primary_breakup_of_a_round_liquid_jet_by_a_coaxial_o_w_of_gas,2006.
[20] CHADHA S.A high-fidelity simulation of the primary breakup within suspension high velocity oxy fuel thermal spray using a coupled volume of fluid and discrete phase model[J].International Journal of Multiphase Flow,2020,133:103445.
[21] 徐小文.AMR自适应结构网格上辐射流体力学显隐耦合时间积分算法[C]//中国工程物理研究院科技年报2011年论文集.绵阳:中国工程物理研究院,2011.
[22] 张磊.界面不稳定性的数值模拟[D].安徽:中国科学技术大学,2003.
[23] RADHAKRISHNAN K.Effect of injection conditions on mixing performance of pintle injector for liquid rocket engines[J].Acta Astronautica,2018,150:105-116.
[24] 李佳楠,雷凡培,杨岸龙,等.强迫扰动下的射流撞击雾化特性[J].航空学报,2020,41(12):124027.
[25] PARK G,LEE J,OH S,et al.Characteristics of gas-centered swirl coaxial injector with acoustic excitation of gas flow[J].AIAA Journal,2016,55(3):894-901.
[26] PARK G,OH S,YOON Y,et al.Characteristics of gas-centered swirl-coaxial injector with liquid flow excitation[J].Journal of Propulsion and Power,2019,35(3):624-631.
[27] 李国能,周昊,尤鸿燕,等.黎开管自激热声不稳定的数值模拟[J].中国电机工程学报,2007,27(23):50-54.
备注/Memo
收稿日期:2022-02-15 修回日期:2022-03-02
基金项目:国家自然科学基金(12002386)
作者简介:谢远(1997—),男,硕士,研究领域为液体火箭发动机喷雾、燃烧。
更新日期/Last Update:
1900-01-01